The 3D models below simulate a trim misalignment caused by miscalibration in one axis.

If you are using the Machine Config settings to correct this, you can negate the values shown above the example (i.e., change positive values to negative and vice versa) and enter them in the corresponding field under Machine Config to properly align your trim.

Example:

If your trim resembles the Y Linear +0.5 mm example, enter -0.5 in the Y (mm) column for the affected machine.

X Linear +0.5 mm

https://my.spline.design/xlinear05-e906a9e2a01d716a497161a3c1dd93f5/

Y Linear +0.5 mm

https://my.spline.design/ylinear05-911051a3560afabb723f751aad9115e6/

Z Linear +0.5 mm

https://my.spline.design/zlinear05-e482edaabd23082486c6185c52f6f053/

X Rotation +2 Degrees

https://my.spline.design/untitled-400d5a44df4e7643603086c1151655c8/

Y Rotation +2 Degrees

https://my.spline.design/yrotation2-bf09125b1aa613c1418bdace0736e1e6/

Z Rotation +2 Degrees

https://my.spline.design/untitled-c63ed594d898c6eb0fbb2a4c95a94384/

Contact ArchMill Applications Support

<aside> 📨 Our Email: [email protected]

</aside>